Distributor
At
every B and C service, replace
the
contact
breaker
points
and
set
the
gap
as
specified
in
technical
data.
·
lightly lubricate
the
cam
B,
and
the centrifugal weights
C.
c
BULB
AND LIGHT
UNIT
REPLACEMENT
Fuses
Eight circuits are
protected
by
fuses:-
Headlight
motor
(up and
down),
offside side lights, nearside sidelights, ignition
controlled circuits, auxiliary controlled circuits and
two
permanent
live circuits.
Side
lamps
and
Flasher
Undo
the
screws, and remove lens.
The
5w. bulb
is
the
side lamp, and
the
21w.
bulb
is
the
flasher. Replace bulbs as necessary,
then
refit lens, correctly positioning
the foam rubber seal,
and
replace and tighten
the
two
screws.
Rear
lamps
and
Brake
lamps
Undo the four screws and remove
the
lens.
The
lower 21w.
bulb
is
the
brake lamp,
and
the
upper
5w.
bulb
the
rear lamp. Replace
the
bulb, refit
the
lens, and replace
and tighten
the
screws.
Rear
Flasher
lamps
Undo
the
two
screws and remove
the
lens. Replace
the
21w. bulb, refit
the
lens,
slipping the inner edge
under
the
rear lamp lens,
and
replace
and
tighten
the
screws.
Reverse
lamps
Undo
the
two
screws and remove
the
lens. Replace
the
21w
bulb, refit
the
lens,
slipping the inner edge
under
the
rear
lamp
lens,
and
replace and
tighten
the
screws.
Head
lamps
The headlamps are raised and lowered by an electric
motor.
This
is
mounted
in
the
front
compartment,
next
to
the
left
hand
lamp
pod.
For
maintenance,
or
in
an
23
I