Setting up your PhysioCarrier baby carrier
Opening the ventilation flap
1515
3. Put the male clip of the lumbar belt into the
safety elastic. Attach the clip and check that it is
secure. You should hear a click.
4. Adjust the strap, then bring the baby carrier
around to the front again.
5. Push the slider of the horizontal strap along
the suspender towards the press stud.
8. You should first try on and adjust the baby
carrier when it is empty, before putting Baby
into it.
2. Turn the belt so the foam side is against you.
Rotate the belt around your waist so that the
baby carrier is behind you.
1. Hold the baby carrier upside down, with the
outside against you.
6. Attach the male clip to the female clip on the
same side, so that the suspender is closed.
7. Loosen the straps of the suspenders attached
to the side of the central compartment.
a. To open the flap, undo the central section’s straps,
to eliminate creases.
b. Pull up the slider of the zipper.
d. To close it, loosen the side straps, unroll the
flap and while holding the zipper at the top, pull
the slider down.
c. Roll up the flap. Attach it with the elastic
bands under it.
To Next Page
Loading...
