Lowrance EP-15 User Manual

1
Pub. 988-0154-371
EP-15 Fluid Level
Electronic Sensor
Installation Instructions
This instruction sheet tells how to install your EP-15 Fluid Level
sensor and connect it to a NMEA 2000

network using LowranceNET
network components. You must refer to your digital gauge, sonar or
GPS unit's manual for sensor operation instructions.
Caution:
Installing LowranceNET NMEA 2000 devices is significantly
different from installing earlier Lowrance components without
NMEA 2000 features. You should read all of the installation
instructions before proceeding. You should decide where to
install all components before drilling any holes in your vessel.
Some sonar or GPS units may require a software upgrade to display
NMEA 2000 data correctly and a manual addendum describing how to
operate the sensor. You can download these free and get additional
information on the NMEA 2000

compatible LowranceNET system at
our web site, www.lowrance.com.
All Lowrance NMEA 2000 capable devices are either NMEA 2000
certified or certification is pending. See our web site for the latest
product status information.
The EP-15 Fluid Level sensor.
Blue female NMEA
2000 connector
Smart
module
Sending unit
connections:
red lead and
black lead.

Lowrance EP-15 Specifications

General

Type	Fluid Level Sensor
Operating Voltage	9-16 V DC
Compatibility	NMEA 2000
Fluid Type	Fuel
Operating Temperature	-20° to 85°C

Summary

EP-15 Fluid Level Sensor Installation

Safety and Installation Precautions

Covers NMEA 2000 installation differences, planning, and crucial safety warnings.

Product Overview and Requirements

Details EP-15 components, function, applications, and necessary NMEA 2000 network connection.

Tools and Supplies

Lists essential tools and the LowranceNET Node Kit for setting up the NMEA 2000 network.

Installation Steps: Wiring and Network Connection

Step-by-step guide for connecting sensor wires to the sending unit and the NMEA 2000 network.

NMEA 2000 Network Setup

Network Bus and Node Configuration

Explains NMEA 2000 network structure, T-connectors, and adding devices to the bus.

Adding Devices to the Network

Details methods for adding new nodes to the network, including using soft T-connectors.

Lowrance Electronics Warranty

Service and Accessory Information