Installing
LayoutDimensional drawing Setup
Upgrade the WIFI-1 software if prompted
Key Description
1
Antenna
2
Ethernet ports x 2
3
Power connector
4
Ethernet LEDs Green: port is active
5
Power LED Red: power on
2 2
4 5
31
+
_
4
4
6
5
8
9
2
3
1
7
Key Description
1
Multifunction display, SonarHub™,
StructureScan™ or other WIFI-1
2
WIFI-1
3
Optional second WIFI-1 to use in Access
Point mode when the primary WIFI-1
is in Client mode. Maintains the ability
of mobile devices to connect to the
navigation network
4
Ethernet cable
5
Power cable
6
Remote power on: WIFI-1 will turn on
when power is applied
7
Fuse or breaker
8
12 V DC
9
Remote power on: WIFI-1 will turn on
when the MFD is turned on (MFD needs
to be set to power on master)
Wiring
References
For a list of supported features or to download
the latest software for your MFD please visit::
www.bandg.com/gofreewww.simrad-yachting.com/gofreewww.lowrance.com/gofree
Compliance statements
This device complies with Part 15 of the FCC Rules and with Industry
Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Identifier: RAYGOFREEWIFI
Select HOME or PAGES key
WIFI-1 features
Marinised construction IPX5
Wireless standards 802.11 b/g
Ethernet network ports 2
Automatic configuration Plug-n-play
Power supply 12 V DC, 200 mA
Supported hotspot security
WPA-PSK, WPA2, WPE 64/128 bit
encryption , TKIP encryption
Specications
¼ Note: Compatible MFDs are required to have software that can support
the GoFree Shop features. Please refer to the support page of the MFD
website to upgrade the MFD. The MFD will then check the firmware
version of the WIFI-1 module and will prompt an upgrade if required.
To Next Page
Need help?
General