Using your Appliance
9
4. Turn the Thermostat Control to the desired position. It is recommended to select the
highest position to pre heat the appliance. It will take 5 -10 minutes for the appliance to
fully heat up. Please note, this appliance will not operate unless positioned on a flat stable
surface or if the thermostat has been set too low.
5. When the room reaches the desired temperature, turn the Thermostat Control slowly
anti clockwise until the appliance goes off with a ‘click’ sound. The heating elements will
temporarily go off.
6. If the room temperature falls below the desired temperature, the heating elements will
turn on again until the room temperature reaches the desired temperature.
Note: this radiator is oil filled, and will cool down slowly after the power is shut off. Allow the
radiator heater to cool prior to any movement, the built in carry handle should be used for
easy movement.
Thermostat Control
Turn clockwise from MIN ‘ 0 ‘ to MAX ‘6’
position
To Next Page
Loading...