BACKHOE REMOVAL
-
-
-
-
Note :
CAUTION :
CAUTION :
Store the backhoe in a dry and clean place with a
roof.
When storing the backhoe outdoors without a roof,
cover the backhoe with a suitable cover to keep
from rain, snow, dirt and other debris.
Grease at all of exposed cylinder rods to prevent
from rusting.
Check all safety decals and parts. If there is any
worn, damaged or missing, repair or replace them.
Important :
Install the dust caps on backhoe hydraulic couplers to
prevent contamination after remove the backhoe.
The hydraulic oil is dangerous for skin or
eyes. Wash the skin and seek medical service if it is
necessary.
STEP 10.
Start the engine, then drive tractor slowly away from
the disconnected backhoe.
Be sure that there is sufficient ballast weight in the
rear tires or an implement is attached to the 3 point
hitch before using the loader without backhoe.
Be careful to avoid injury during removal of
the backhoe.
Turn off the tractor engine. Relieve hydraulic pressure
by actuating all the control levers in each direction,
then disconnect the backhoe hose couplers from the
tractor hydraulic couplers.
STEP 9.
Backhoe Storage
From
Tractor ports
Dust Cap
- 25 -
To Next Page
Loading...
Need help?
General
