LS SV-xxx-iP5A-2 - Chapter 4 - Operation; Programming Keypad Operation

Chapter 4 - Operation
4-1
CHAPTER 4 - OPERATION
4.1 Programming Keypads
4.1.1 LCD Keypad
LCD keypad can display up to 32 alphanumeric characters, and various settings
can be checked directly from the display. The following is an illustration of the
keypad.
32 character,
background light, LCD
display. The
background tone is
adjustable.
The Mode Button
moves you through the
seven program groups:
DRV [Mode] 
FU1 [ENT]DRV
The Program Button is used
to go into programming
mode to change data.
The Enter Button is used to
enter changed data within a
parameter. DRV
[ENT] APP [MODE]
 DRV
[SHIFT] This button is used
to move cursor across
display in programming
mode.
[ESC] This button is used to
move the program code to
DRV 00 form any program
code.
Reverse Run Button
The Reverse Run LED
blinks when the drive
Accels or Decels.
Forward Run Button
The Forward Run LED
blinks when the drive
Accels or Decels.
Stop Button is used to stop the
drive from running.
(It has the priority over the
parameter setting.)
Reset Button is used to reset
Faults.
LED blinks when there is a fault.