LSIS EMPR Series - Page 51

50 Electronic Motor Protection Relays
  


  
  
3. Set the operating time

It refers to the time of delaying EMPR operation in order to prevent Trip from a motor’s staring current.





It refers to the time taken from the start of overcurrent to EMPR Trip. After the set O-Time, EMPR is Tripped.



 Set the operating current 







5 Check the LED condition when operation

Definite time characteristic 1
1 Check the rated voltage and
apply the control power to A1
and A2 terminal



2. Check the Test/Reset button
operation








current(s)
time(%)




Operation

setting method