Chapter 7. Storage Function
7-3
7.4 Updating the Device through Storage Equipment
1. If you touch [Project Upload], the following dialog shows.
2. In case of selecting [USB], the directory list under the path, \USB Storage\XP_Project\ shows. In case of selecting [CF],
the directory list under the path, \Storage Card\XP_Project\ shows. In case of updating the device by using storage
equipment, the XGT Panel Software project should be saved in the one lower directory between those two directories.
3. If you touch [OK] button, the device is updated with XGT Panel Software in the designated path.
(1) Do not remove USB storage equipment or turn off the device during operation. It may cause abnormal installation of
project data.
(2) Do not remove or move the directory except CF or USB storage equipment. It may cause abnormal operation.
To Next Page
Loading...
