Installation Instructions
1 | P a g e v 1 . 0 ( 1 0 / 2 0 1 8 )
SENTINEL 2 LIGHTS SPOT LIGHT WITH PIR SENSOR
SKU# 240735, 240736, 240737
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep instructions for future reference.
Warranty
• This luminaire (SKU# 240735, 240736) is covered by a 12 month warranty. The luminaire
by 5 year warranty. The warranty is from date of purchase, not the date of installation.
• If the luminaire is not assembled and installed by a licensed electrician the warranty will be void.
• Please retain proof of purchase and evidence of installation by a licensed electrician.
• Warranty will be void if there is any damage due to improper usage or modification to the luminaire.
• Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.
Installation requirements
• Must be assembled and installed by a licensed electrician.
• All wiring and installation of the luminaire must adhere to latest local and national wiring rules.
Eg. AS/NZS 3000 Electrical installations.
• Do not exceed the maximum wattage rating.
• Select a suitable location for installation:
- This luminaire is protected against water penetration to IP65 standards, which is against low pressure jets of
water from all practicable direction. This must be maintained during installation.
- It is suitable for indoor or outdoor use.
- The mounting point must support 2 times the weight of the luminaire.
• Take care not to pull any electrical wires during unpacking as this may damage the connection.
• Lay out all the components on a smooth surface and make sure there are no components missing before assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
• Check whether the luminaire
has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
PIR sensor information
PIR (PASSIVE INFRA RED) SENSOR:
The luminaire has a PIR (Passive Infra Red) sensing device which continuously scans the operating zone and immediately
switches the light on when it detects movement in that area. Whenever movement is detected within the range of the
sensor, the light will switch on automatically to illuminate the area. While there is movement within the sensor range, the
light will remain on.
SENSOR LOCATION & INFORMATION:
To find a suitable location for installation, please take into consideration the following points:
• The ideal mounting height for the luminaire is between 1.8m to 2.2m above the detection area. Fig 1.
• The detection area is approximately 5 metres away at an angle of 90° wide. This may vary depending on the mounting
height and location.
• The detection area may also alter at different temperatures. PIR sensors are more sensitive in cold weather than warm
weather.
• The sensor has better sensitivity with movement across the detection area. Fig 2.
• The sensor has reduced sensitivity with movement towards and away from the detection area. Fig 3.
To Next Page
Need help?
General