Installation Instructions
1 | Page v 1 . 1
LEDlux Canteen
SKU# 020375, 020376, 020377, 020378, 020379, 020380
Rated Voltage 220-240V~ 50Hz
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of this product. Please keep instructions for future reference.
• This fitting is covered by a 3 year warranty. The warranty is from date of purchase, not the date of installation.
• If the fitting is not installed by a licensed electrician it will void the warranty.
• Please retain proof of purchase and evidence of installation by a licensed electrician for any warranty enquiries.
• The use of non-recommended dimmers may damage your LED light fitting and will void the warranty.
• Warranty will be void if there is any damage due to improper usage or modification to the fitting.
• Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.
Installation requirements
• Must be installed by a licensed electrician.
• All wiring and installation of the light fitting must adhere to local and national wiring rules.
eg. AS/NZS 3000:2007/Amendment 2:2012 Electrical installations.
• Select a suitable location for installation;
- This product is suitable for indoor use only.
- The mounting point must support 2 times the weight of the fitting.
- Ensure the fitting is not installed in direct line of an air vent/system and is not placed in any moist of damp areas.
• This fitting is dimmable and has been tested with Lucci LEDlux SKU# 290998 dimmer, Clipsal 32E450TM and
Clipsal 32E450UDM dimmers only. The use of a LED dimmer such as the Lucci LEDlux SKU# 290998 dimmer is
highly recommended.
NOTE: For the best dimming range, use with the Lucci LEDlux SKU# 290998 dimmer and adjust the variable
resistor at minimum and maximum dimming positions on the dimmer during the installation.
NOTE: The use of non-recommended dimmers may damage your LED light fitting and will void the warranty.
NOTE: Dimming may cause buzzing sounds or a slight flicker. There may be slight delays with the LED light start
up or slight uneven light performance when more than one LED light fitting is linked together, switched ON or
dimmed. This is not a product fault and as such is not covered under warranty.
NOTE: Some dimmers have a minimum load of 20W. Ensure the dimmer position is on the maximum setting before
turning on the LED light and adjust the dimmer down to your desired light level.
• Take care not to pull any electrical wires during unpacking as this may damage the connection.
• Lay out all the components on a smooth surface and make sure there are no components missing before
assembling. If parts are missing, return the complete product to the place of purchase for inspection or replacement.
• Check whether the fitting has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
• Ensure power to the circuit you are working on has been switched OFF before commencing any electrical work.
To Next Page
Need help?
General