Installation Instructions
1 | P a g e v 1 . 0 ( 0 9 / 2 0 1 8 )
TEMPO LED TABLE LAMP WITH BLUETOOTH SPEAKER
SKU# 259120
Rated Voltage 5V DC
Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all
instructions carefully before assembly, installation and use of the product. Please keep the instructions for future reference.
Warranty
• This product is covered by a 3 year warranty. Please retain proof of purchase.
• Warranty will be void if there is any damage due to improper usage or modification to the product.
• Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void warranty.
Installation requirements
• Select a suitable location for the fitting:
- Ensure it is on a flat and stable surface.
- This product is suitable for indoor use only.
- Do not place flammable material near or over the fitting.
- Ensure the fitting is not installed next to any air vents and is not in any moist or damp areas.
• Only use the supplied power adaptor to charge this fitting.
• Take care not to pull any electrical wires during unpacking as this may damage the connection.
• Lay out all the components on a smooth surface and make sure there are no components missing before
assembling.
If parts are missing, return the complete product to the place of purchase for inspection or replacement.
• Check whether the fitting has been damaged during transport. Do not operate/install any product which appears
damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
• Do not plug into the mains power socket outlet before or during assembly. Only do so after the portable lamp is fully
assembled and ready to use for the first time.
Installation directions
Operation of the portable lamp:
1. Turn on the power switch.
2. Press to turn the light on.
3. Press and hold to adjust the brightness.
4. Adjust the lamp head to your preferred lighting angle.
5. Press again to turn the light off.
Operation of the Bluetooth speaker:
1. Turn on the power switch.
2. Press and hold until the status indicator flash. There will be a prompt tone to indicate the Bluetooth mode is
turned on.
3. Turn on the Bluetooth device in your phone/tablet and search for devices in the Bluetooth menu.
4. When ‘Tempo range’ appears in the Bluetooth device list, select the ‘Tempo range’ to pair and connect. (If your
phone request a pairing code, please enter 0000).
5. After successful pairing, there will be a prompt tone and the status indicator will flash.
6. During music play back:
To Next Page
Need help?
General