Lucent Technologies SLC 5 Series - Page 21

SLC‚ Series 5 Remote Terminal 363-205-401 TOP
xviii
Issue 7 March 1997
Continued on next page
Conversions Tab Index
Element Title
IXL-001 Conversions Tab Index
NTP-002 Acceptance
NTP-003 Convert Series 5 RT from Feature Package A Capability to Feature
Package C Capability
NTP-004 Convert Feature Package A or C RT to Feature Package C-AutoCut
NTP-005 Convert Series 5 RT from Feature Package B Mode 2 to Feature
Package B Mode 1
NTP-006 Convert Series 5 RT from Feature Package B Mode 1 to Feature
Package B Mode 2
NTP-007 Add Special Service Capability to Feature Package B RT
NTP-008 Add or Remove Protection Line Option
NTP-009 Convert Series 5 RT to Any Feature Package Capability Generic
Procedures
NTP-010 Convert Feature Package B Mode 1 or Mode 2 to Feature Package
303
NTP-011 Reinstate Feature Package B Following a Failed Conversion to
Feature Package 303
TAP-100 Clear FAIL LED Problems on a Unit During Turnup and Conversion
DLP-500 Verify That Correct Complement of Circuit Packs is Available
DLP-501 Install AUB27 Alarm Display Unit (ADU) for FPC Conversion
DLP-502 Install Bank Control Unit (BCU) for FPC Conversion
DLP-503 Install Channel Test Unit (CTU)
DLP-504 Install Digital Test Unit (DTU)
DLP-505 Set ZCS LIU Line Coding Option for Feature Package C-AutoCut or
FPB Mode 2 Conversion
DLP-506 Install AUB27 Alarm Display Unit (ADU) for Feature Package B Mode
1 or Mode 2, or FPC-AutoCut Conversion