Lucy Zodion SS12 CONNECT User Manual

Further Technical Data:
• Consumption: <250mW.
• Operating Temp: -20°C + 80°C. ● Switching Delay = 10-30s.
• Enclosure Material: UV stabilised polycarbonate.a
• Compliance: EN55015, EN61000, EN61347, EN61547 (applicable parts thereof)
SS12
CONNECT
Installation Guide
Zodion
www.lucyzodion.com
Lucy Zodion Ltd
Station Road
Sowerby Bridge
West Yorkshire
HX6 3AF
T +44 (0)1422 317 337
sales@lucyzodion.com
IGSS12C-0517-V1

Lucy Zodion SS12 CONNECT Specifications

General

Product Type	Photocell
IP Rating	IP65
Frequency	50/60Hz
Weight	150g
Material	Polycarbonate

Summary

Further Technical Data

Consumption

Specifies the power consumption of the device, noted as less than 250mW.

Operating Temperature Range

Details the acceptable temperature range for operation, from -20°C to +80°C.

Switching Delay

Indicates the delay time for switching operations, specified as 10-30 seconds.

Enclosure Material

Identifies the enclosure material as UV-stabilised polycarbonate.

Compliance Standards

Lists applicable compliance standards including EN55015, EN61000, EN61347, EN61547.

Installation Steps

Pre-installation Checks

Instructions to isolate electrical supply and check lantern hole dimensions before mounting.

Mounting Preparation

Guidance on unscrewing the M20 nut and washers and ensuring mating surfaces are clear.

Photocell Installation to Lantern

Steps for pushing the photocell turret through the lantern hole and tightening the M20 nut.

Wiring Loom Connection

Instruction to click the wire harness into the photocell unit for connection.