Need help?Do you have a question about the Lull OmniQuip 644D-34 and is the answer not in the manual?
Details regarding warranty registration and pre-delivery inspection.
Notes on manual retention, replacement, and engine manufacturer recommendations.
Explains the meaning and importance of the safety alert symbol.
References the ASME/ANSI B56.6 safety standard for rough terrain forklifts.
Importance of machine decals for safe operation and correct usage.
Explains the Roll-Over Protective Structure and Falling Object Protective Structure.
Guidelines and precautions to follow during machine refueling operations.
Requirements for operators, including training and understanding manual instructions.
Recommendations for protective clothing and personal safety devices.
Factors affecting machine stability and potential causes of instability.
Essential checks and procedures before starting the machine engine.
General rules and safe habits for operating the machine.
Procedures to follow when leaving the machine unattended.
Steps required before exiting the operator's cab.
Further safety guidelines for careful operation and hazard avoidance.
Explains the function and normal ranges of various machine gauges.
Describes the meaning and function of different indicator lights on the panel.
Details the location and four positions of the ignition switch.
How to use the engine throttle pedal to control engine speed.
Instructions for using the service brake pedal to slow or stop.
Operation of the parking brake switch and its indicator lamp.
Controls machine travel direction and transmission speed range selection.
Procedure for locking the shift lever in the NEUTRAL position.
Function of the declutch switch for hydraulic system operation.
Explains the three available steer modes: Oblique, Front Wheel, Round.
Describes the "2-Wheel Steer" mode for conventional steering.
Details the "Crab Steer" mode for steering front and rear wheels.
Explains the "4-Wheel Steer" mode for opposite direction steering.
Procedure to straighten and align wheels after changing steer modes.
Overview of joystick functions for boom, extension, and tilt.
Reference decal showing how to activate joystick functions.
How a switch on the joystick modifies its function.
Shows the boom angle relative to level ground for load capacity.
Displays the side-to-side angle of the machine frame.
Used to level the machine laterally using a control lever.
Daily checks required for the forklift to ensure operational readiness.
Importance of inspecting the worksite for potential hazards before operation.
Identifies specific conditions that can lead to loss of control, collision, or tipover.
Guidance on planning routes, loads, and work areas for safe operation.
Requirements for operators to be qualified, authorized, and alert.
Emphasizes understanding employer rules, traffic signs, and signals.
Recommendations for wearing personal protective equipment (PPE).
Safe procedures for entering and exiting the machine using three-point contact.
Step-by-step guide on how to safely start the machine's engine.
Correct steps for safely shutting down the machine after use.
Guidelines for safe travel over various terrains and conditions.
General safety rules to follow during all machine operations.
Procedures for safely lifting loads, checking load charts, and capacity.
Safe practices for transporting loads, including load height and visibility.
Steps for correctly placing loads at landing points, including elevated placement.
Warning against using the forklift as a personnel lift and conditions for it.
To Next Page
General
