EasyManua.ls Logo

Lumag RP-110HP - User Manual

Lumag RP-110HP
32 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
GB
Instruction Manual
Compactor
www.lumag-maschinen.com
Art. No.: RP-110HP
RP-110HP
RP-110HP_manual_GB.indd 1 04.02.2010 09:22:45

Table of Contents

Questions and Answers

  • B
    Bryan JohnsonAug 9, 2025
    What to do if my Lumag RP-110HP Other motor doesn't start?
    • A
      Angela KiddAug 9, 2025
      If your Lumag Other motor doesn't start, several issues could be the cause. First, check if there is gas in the tank and refill if necessary. Ensure the fuel tap is open. Also, inspect the air filters for contamination and clean them if needed. Make sure the power switch is in the ON position. Check the oil level and refill if low. If these steps don't resolve the issue, the starting unit may be faulty and require repair.
  • K
    Keith OlsonAug 23, 2025
    Why is the working speed of my Lumag RP-110HP Other too low?
    • T
      Thomas SmithAug 23, 2025
      If the working speed of your Lumag Other is too low, and the plate doesn't reach its highest speed, there are several potential causes. The gas lever may be assembled incorrectly, requiring adjustment. If the surface is too wet, the compactor could be getting stuck, so allow the foundation to dry up. The belt might not be tight enough, causing it to skid; adjust the belt tension or replace it, and check the motor bolts for proper pulling. Lastly, dirty air filters can also reduce performance, so clean or replace them.

Lumag RP-110HP Specifications

General IconGeneral
Compaction depth30 cm
Engine typeHonda GX160
Engine power4.1 kW
Forward speed25 m/min
TypeReversible Plate Compactor