EasyManuals Logo

LumaSense E2T PULSAR 4 User Manual

Default Icon
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
IMPAC Non-Contact Infrared Temperature Sensors
IMPAC Non-Contact Infrared Temperature Sensors
PULSAR 4 Quick Start Guide
Change Measuring Mode See Section 5.8.1 of the manual for more information.
Both analog outputs correspond to the displayed measuring temperature RT, GT, or FF.
1. Press and hold the “Out” button (both LEDs Out1 and Out2 on).
2. While holding the “Out” button down, press the “Mode / Save” button to switch the displayed/
measuring temperature between RT, GT, or FF.
3. Release the “Out” button to exit (both LEDs Out1 and Out2 off).
Adjust Emissivity See Section 5.8.2 of the manual for more information.
Press or and release to show the current emissivity for the selected mode (e.g. “RT”) without
changing.
Press or again to increase or decrease the emissivity value for the selected mode
temperature.
Note: The value changes more quickly the longer the button is held. If the parameter was changed, the
display will pulsate. By pressing the “Mode / Save” button, the value is accepted (stored) and the display
changes to the temperature for the selected measuring mode. If the new value is not stored with the
“Mode / Save” button within 30 seconds after the last pressing of a button, the display changes to tem-
perature indication without storing the emissivity changes.
Note: The “FMA” button has no function in the standard PULSAR 4 (without the Advanced option).
Also, in the standard version (without the Advanced option), the “Mode / Save” button works only in its
“Save” function.
PULSAR 4 Standard

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LumaSense E2T PULSAR 4 and is the answer not in the manual?

LumaSense E2T PULSAR 4 Specifications

General IconGeneral
BrandLumaSense
ModelE2T PULSAR 4
CategoryThermometer
LanguageEnglish