Why does my Lumen Dynamics Group OmniCure S2000 show alternating 'Old' and 'Bulb' messages?
If your Lumen Dynamics Group Lighting Equipment displays alternating messages of 'Old' and then 'Bulb', it indicates that the lamp has been used for more than 2000 hours. The lamp may be nearing the end of its lifespan.
What to do if Lumen Dynamics Group OmniCure S2000 shows a 'Cool Warning'?
If you receive a 'Cool Warning' on your Lumen Dynamics Group Lighting Equipment, it means the lamp is too hot to ignite. The lamp will automatically attempt to re-ignite once it has cooled down to the optimal temperature.
What to do if my Lumen Dynamics Group OmniCure S2000 Lighting Equipment says 'Wrong Type of Lamp Installed'?
If your Lumen Dynamics Group Lighting Equipment indicates a 'Wrong Type of Lamp Installed', you should check the lamp part number to ensure the correct lamp type is installed.
General| Category | Lighting Equipment |
|---|---|
| Cooling System | Integrated fan |
| Input Voltage | 100-240 VAC, 50/60 Hz |
| Power Consumption | 300 W |
| Operating Temperature | 10-40°C |
| Light Source | Mercury short arc lamp |
| Wavelength | 320-500 nm |
| Spectral Output | Broadband |
| Power Output | 200 W |
| Intensity Control | 0-100% adjustable |
| Light Delivery | Liquid Light Guide |
| Cooling Method | Forced Air |
| Lamp Life | 2000 hours |
| Relative Humidity | 20-80% non-condensing |
Lists all items included in the S2000 package for initial setup.
Details how to adjust light output percentage in Relative Mode when the CAL LED is off.
Explains how to adjust light output in Absolute Mode using a calibrated system.
Details the process of setting the exposure duration in seconds and tenths of seconds.
Specifies the COM port settings (baud rate, data bits, etc.) for PC communication.
Details the format and protocol for commands and responses between the PC and S2000.
Lists and explains the various commands available for remote control of the S2000.
Covers settings for Iris Level, Intensity Level, Exposure Timer, and Shutter Control.
Details the conditions that trigger alarms and how to clear them.
To Next Page