Lumex 2060R - User Manual

2060R-INS-LAB-RevC15 1
2060R ROUND BATH STOOL:
ASSEMBLY AND OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
Info: The most current version of these instructions can be found online at www.grahamfield.com.
WARNING: Important! Read and understand these instructions before assembling or using
the Round Bath Stool. If you do not understand any part of these warnings, cautions or
instructions, contact a healthcare professional for direction in the use of this product. If the
Round Bath Stool is not properly assembled, personal injury and damage to the Round Bath
Stool could result.
WARNING: If components are damaged or missing, contact your GF authorized distributor
immediately. DO NOT use substitute parts. Use only Lumex replacement parts. The use of non-
Lumex replacement parts could cause personal injury, property damage, and void the warranty.
WARNING: This product's maximum weight capacity is 300 lb, EVENLY DISTRIBUTED.
DO NOT exceed the maximum weight capacity.
WARNING: Notice for California Customers- California Proposition 65 WARNING: This product
contains a chemical known to the State of California to cause cancer and reproductive or
developmental harm.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury
caused by improper assembly or use of this product.
INTENDED USE
The 2060R Round Bath Stool is intended as a bath
aid.
UNPACKING
Remove Bath Stool components from carton and
protective packaging. Check for obvious damage
to the carton or its contents. If damage is evident,
do not use the product; please notify the carrier
and your GF authorized distributor for further
instruction.
ASSEMBLY
1. Lay bath seat upside down with upper legs
pointing up on a at, dry surface.
2. Attach lower leg by pushing in the locking
button and sliding the lower leg over the upper
leg until it clicks into place. Repeat for other
three legs. Ensure all legs are locked before
proceeding.
WARNING: Before proceeding, ensure all
locking buttons protrude fully from leg
attachment holes.
Height Adjustment
Depress adjustment button and slide lower leg
up or down until height adjustment button clicks
into place at desired height. Repeat for other three
legs. Ensure all legs are locked at the same height.
WARNING: Before use, ensure all adjustment
buttons protrude fully from height
adjustment holes, and all legs are adjusted
to the same height.
2060R Bath Stool components
seat
(with upper
legs attached)
legs
2060R Bath Stool assembled
locking
button
2060R Bath Stool height adjustment
lowest
highest
height adjustment button

Summary

Intended Use and Unpacking

Intended Use

The 2060R Round Bath Stool is designed as a bath aid.

Unpacking Instructions

Remove components from packaging and check for damage before use. Notify carrier if damage is found.

Assembly and Height Adjustment

Assembly Steps

Attach legs by pushing locking buttons until they click. Ensure all legs are secured.

Height Adjustment

Depress button to slide legs to desired height. Ensure all legs lock at the same height.

Safe Usage and Positioning

Positioning Guidelines

Use caution on wet surfaces, sit centrally, avoid tipping, and ensure all leg tips contact the floor.

Maintenance and Warranty

Product Maintenance

Inspect weekly. Clean with mild soap and water. Avoid solvents or abrasive cleaners.

Limited Warranty Information

Summary of GF Health Products, Inc. warranty for parts and workmanship under normal use.

Overview

1. Function Description
2. Important Technical Specifications
3. Usage Features
4. Maintenance Features
5. Warranty Information
6. Safety Warnings

The Lumex 2060R Round Bath Stool is a bath aid designed to provide support and stability for individuals during bathing. This manual outlines the assembly, operation, and maintenance of the device, emphasizing safety precautions and proper usage.

Function Description:

The primary function of the 2060R Round Bath Stool is to offer a secure and stable seating option in wet environments such as showers or bathtubs. It is intended to assist users who may have difficulty standing for extended periods or require support to prevent falls while bathing. The stool features adjustable legs, allowing users to customize its height for optimal comfort and accessibility. Its design prioritizes stability and ease of use, making it a practical aid for individuals seeking greater independence and safety in their daily hygiene routines.

Important Technical Specifications:

• Model: 2060R Round Bath Stool
• Maximum Weight Capacity: 300 lb, evenly distributed. It is crucial not to exceed this limit to ensure user safety and prevent damage to the stool.
• Components: The stool consists of a round seat, upper legs (attached to the seat), and lower legs which attach to the upper legs. Each lower leg is equipped with a locking button for secure attachment and an adjustment button for height modification.
• Materials: While specific material details are not explicitly provided, the instructions emphasize using only Lumex replacement parts, suggesting that the materials are chosen for durability and compatibility with the intended wet environment. The product is manufactured in China.

Usage Features:

• Assembly:
  1. Begin by placing the bath seat upside down on a flat, dry surface, with the upper legs pointing upwards.
  2. To attach the lower legs, depress the locking button on a lower leg and slide it over an upper leg until it clicks securely into place. This process should be repeated for all three legs.
  3. A critical safety check after assembly is to ensure that all locking buttons fully protrude from their respective leg attachment holes, confirming that the legs are securely locked.
• Height Adjustment:
  1. To adjust the stool's height, depress the adjustment button on a lower leg.
  2. Slide the lower leg up or down to the desired height until the adjustment button clicks into place, indicating it is locked.
  3. This process must be repeated for all three legs.
  4. Before use, it is imperative to ensure that all adjustment buttons fully protrude from their height adjustment holes and that all legs are adjusted to the same height. This ensures the stool's stability and prevents tipping.
• Positioning and Safety:
  • Always exercise caution when using the bath stool on wet or slippery surfaces.
  • Ensure the bath stool is securely positioned during use.
  • For proper balance and stability, users should always sit on the middle of the seat.
  • To prevent falls or tipping, users should seek assistance until they are familiar with the stool's balance points.
  • Avoid putting downward weight on only one side of the bath stool.
  • Do not reach or lean if it requires shifting weight. If an object is out of reach, ask for help or use an extension device.
  • Never attempt to reach an object if it means moving forward in the seat and losing full contact with the seat with your buttocks. Similarly, do not lean backward to reach an object.
  • All four leg tips must remain in contact with the shower or tub floor at all times to maintain stability.

Maintenance Features:

• Regular Inspection: The bath stool should be inspected weekly for proper function and wear. This includes checking for any signs of damage, loose components, or worn parts.
• Damage or Missing Components: If any components are damaged or missing, contact a GF authorized distributor immediately. It is crucial not to use substitute parts and to use only Lumex replacement parts to ensure safety and maintain the warranty.
• Cleaning:
  • To clean the bath stool, use a mild soap and water solution with a clean cloth.
  • Rinse the stool thoroughly with clear water.
  • Dry the stool with a soft cloth.
  • Ensure the bath stool is well-rinsed and dry before its next use.
• Cleaning Precautions: Do NOT use solvents, abrasive cleaners, or scouring pads on any part of the bath stool, as these can damage the materials and finish.

Warranty Information:

GF Health Products, Inc. provides a limited warranty for the 2060R Round Bath Stool. The frame is warranted for five (5) years, while normal wear components such as tips, wheels/casters, and handgrips are warranted for six (6) months. The warranty covers defects in material or workmanship under normal use and service. It is for parts only and does not include labor or shipping costs. The warranty is conditional upon proper use according to GF instructions. Exclusions include defects caused by misuse, abuse, negligence, alteration, accident, freight damage, tampering, or failure to seek timely repair/replacement. The complete warranty details are available on the Graham-Field website. To obtain warranty service, customers should contact the Dealer from whom the product was purchased or GF directly if there is no Dealer.

Safety Warnings:

The manual includes several prominent warnings, highlighted by a triangle symbol, to ensure user safety. These cover critical aspects such as proper assembly, avoiding damaged components, adhering to weight capacity limits, safe positioning, and regular maintenance. A specific California Proposition 65 warning is included, indicating that the product contains a chemical known to cause cancer and reproductive harm. GF Health Products, Inc. explicitly states it assumes no responsibility for injury or damage resulting from improper assembly or use.

Lumex 2060R Specifications