Lumex AQ1000 - Electrical Connections and Safety

10 AQ1000-INS-LAB-RevD13
5. Connect one end of the air tubes to the bubble pad:
slide the ends of the air tubes over the connectors on
the top of the foot end of the bubble pad.
6. Connect the other end of the air tubes to the pump
connectors; ensure that the ends of the air tubes are
rmly tted over the bubble pad and pump connectors
before continuing.
s NOTICE:Ensurethattheairtubesarenotkinkedor
tuckedunderthebubblepadormattress.
WARNING:Locateallcordssothattheywillnotbe
steppedon,trippedover,orotherwisesubjectedto
damageorstress.
WARNING:Donotuseahouseholdextensioncordif
theelectricalcorddoesnotreachthepoweroutlet.Use
ofanimproperextensioncordcouldresultinreand
electricshock.Ifanextensioncordmustbeused,use
athreeconductorcordwithground,properlywired,
ingoodelectricalcondition,andkeepitasshortas
possible.
WARNING:Thisdevice—whichMUSTbegrounded—is
equippedwithacordthathasagroundingwirewith
agroundingplug.Theplugmustbepluggedintoan
outletthatisproperlyinstalledandgrounded.
WARNING:Ensurethatthelocalpowervoltageis
appropriateforthepumpunit.
7. Plug the power cord into a properly grounded electrical
outlet.