Lumi-O The Royal Entrance 5602 User Manual

1. Insert the rails into the step (short rails on top) and align
with the predrilled holes. Attach using the 3” bolts (8),
washers (16), and nuts (8). Slide the braces over the short
rails and leave unattached (Fig. 1).
3. Pour sand* (approx. 50 lbs.) into the fence until it is 3/4
full (Fig. 3). Install the cap properly with the 3/4” screw.
5. Lower the step into the water. Move it to its permanent
location and level it horizontally.
IMPORTANT: Leave a minimum of 1” of space between
the pool wall and the step.
6. Lower the braces until they rest on the deck. Attach using
the 10 x 3/4” screws (8) (Fig. 5). See the circled section (Fig. 5)
2. Insert the diagonal rails onto the long and short rails.
Attach using the 10 x 3/4” screws (4) (Fig.2).
4. Slide the fence into the step and push it towards the foot
of the step (Fig. 4).
CAUTION: The safety fence is not supposed to touch the
liner.
7. Attach the braces to the deck using the 1-3/4” srews (10).
If the deck is above the toprail, attach the braces directly to
the deck (Fig. 6).
Note: Number in ( ) refers to quantity to be used.
!
!

Lumi-O The Royal Entrance 5602 Specifications

General

Brand	Lumi-O
Model	The Royal Entrance 5602
Category	Ladders
Language	English

Summary

Pool Step Installation Procedures

Assemble Step Rails and Braces

Insert rails into the step, align holes, and attach with bolts. Slide braces over short rails.

Attach Diagonal Rails and Fence

Insert diagonal rails, attach with screws. Fill fence with sand and position it.

Position and Secure Step in Pool

Lower step into water, level it, ensure space from wall, and attach braces to deck.

Adjust Brace Leveling with Shims

Shim braces to match pool level if deck is lower or vice-versa.

Safety and Maintenance Guidelines

Consolidates safety warnings and outlines two simple steps for pool step maintenance.