To Next PageTo Next Page
Need help?Do you have a question about the Luminance Brands RCK55 and is the answer not in the manual?
Observe intended use, ensure power is off before servicing, and follow all wiring codes.
Read the Owner's Manual carefully before installing the Receiver and retain for future reference.
Ensure no bare wires are exposed outside the wire connectors during installation.
All wiring must comply with NEC/local codes; use a licensed electrician if unsure.
Use only with capacitor speed controlled fans to prevent fire, shock, or injury.
Lists all parts and hardware included in the RCK55 Receiver carton.
Remove housing, disconnect motor, remove speed switch, and install pull chain plug.
Specific wiring steps for CF2400, CF4500, CF4501, CF4800, CF4801 models.
Steps for CF3900, CF4500, CF4501, CF4800, CF4801 models.
Steps for CF1, CF2000, CF2800 models.
Specific wiring steps for CF2400 model.
Steps for separating capacitor and removing wiring harness/switches.
Steps for closing switch housing holes with plugs.
Positioning and connecting the new reverse module.
Connecting motor wires to the reverse module wires.
Securing the switch housing cover.
Separating yellow wires from motor coupler for specific models.
Capping one yellow wire and joining another with the 80" fan yellow wire.
Cutting orange wire and joining 80" fan yellow wire to housing orange wire.
No wiring changes are required for CF1 and CF3900 models.
Route wires through hanger bracket and position receiver in ceiling cover.
Connect ground wires securely using wire connectors.
Connect receiver white wire to supply and fan white wires.
Connect receiver black wire to fan black wire.
Connect receiver black/white wire to supply black wire.
Connect receiver blue wire to fan blue wire (bottom light).
Connect receiver yellow wire to fan yellow wire (uplight).
Insert connected wires into ceiling outlet box; check connections.
Mount receiver, secure ceiling cover, and install optional light fixture.
Diagram showing receiver, supply, and ceiling fan wire connections.
Check pull chain speed, battery, and wiring.
Try moving the antenna wire outside the ceiling cover.
General| Brand | Luminance Brands |
|---|---|
| Model | RCK55 |
| Category | Home Automation |
| Language | English |
