Page 7For technical questions, please call 1-888-866-5797.Item 62565
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INSTRUCTIONS section at the beginning of this
manual, including all text under subheadings therein before setup or use of this product.
1. Plug the Light into a standard 120V
grounded, electric outlet.
2. Push the On/Off Switch on the back of the Light.
3. WARNING! Keep the Light away from
combustible objects. The Light and housing
will get hot enough to start a fire.
4. To turn off, push the On/Off Switch.
5. To prevent accidents; turn off Light and
disconnect power supply after use.
Allow the Lights to cool. Clean, then store
the Light indoors out of children’s reach.
On/Off
Switch
Figure D
Maintenance And Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the On/Off Button is in the OFF position and unplug the tool from
its electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM LIGHT FAILURE:
Do not use damaged equipment. If damage is noted, have the problem corrected before further use.
1. BEFORE EACH USE, inspect the general
condition of the Light. Check for:
• loose hardware
• damaged cord/electrical wiring
• cracked or broken parts
• any other condition that may
affect its safe operation
2. AFTER USE, allow Light to cool and then wipe
external surfaces of the Light with a clean cloth.
WARNING! If the supply cord of this
light is damaged, it must be replaced only
by a qualified service technician.
Note: Replacement parts may not
be available for this item.
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
To Next Page
Loading...