Lumiscope 2000-T User Manual

2000-T-INS-LAB-RevC14 8
ATTACHING THE LEAD WIRES
WARNING: Ensure the device is OFF before connecting the lead wires.
WARNING: Never insert the lead wire plug into an AC power supply
socket. Personal injury and/or damage to the TENS unit could occur.
s CAUTION: Use care when you plug and unplug the wires. Pulling on the
lead wire instead of its insulated connector may cause wire breakage.
The lead wires provided with the TENS device insert into the ports located
on top of the unit. Holding the insulated portion of the connector, push the
plug end of the wire into one of the ports; one or two sets of the wires may
be used. After connecting the wires to the stimulator, attach each wire to an
electrode.
Lead wires provided with the TENS device are compliant with mandatory
compliance standards set forth by FDA.
ELECTRODE SELECTION AND CARE
Using Electrodes
Use the electrodes as prescribed. Follow application procedures outlined in
electrode packaging to maintain stimulation and prevent skin irritation. The
electrode packaging provides instructions for care, maintenance, and proper
storage of electrodes.

Lumiscope 2000-T Specifications

General

Brand	Lumiscope
Model	2000-T
Category	Massager
Language	English

Summary

Introduction to TENS

How TENS Works

Explains how TENS stimulates nerves to reduce pain sensation and release endorphins.

Indications and Contraindications

Lists approved uses and conditions where TENS should not be applied without physician consultation.

Contraindications

Lists conditions and placements where TENS should not be used without consulting a physician.

Safety and Precautions

General Warnings

Key safety warnings including child safety, pregnancy, effectiveness, and operation precautions.

Specific Warnings

Warnings about equipment interference, electrode placement, curative value, and California Proposition 65.

Precautions and Adverse Reactions

Precautions regarding skin irritation, doctor qualification, and potential adverse reactions like burns.

Device Overview and Components

About This Device

Overview of the battery-operated TENS device and its controls like intensity, pulse width, and mode.

System Components

Lists the TENS unit, accessories, and the required 9-Volt battery.

Unit Controls and Operation

Unit Controls Description

Details the panel cover, intensity knobs, mode switch, pulse width, and pulse rate controls.

Operating Modes Explained

Describes the Burst (B), Continuous (C), and Modulation (M) modes and their parameters.

Setup and Usage

Attaching Lead Wires

Instructions on safely connecting lead wires to the unit, with warnings about device power and AC sockets.

Electrode Selection and Care

Advises using electrodes as prescribed and following packaging for application, care, and storage.

Tips for Skin Care

Provides essential tips for skin preparation, electrode application, removal, and general skin care for optimal use.

Connecting the TENS Device

Step-by-step guide for inserting the battery, preparing the skin, connecting lead wires, and placing electrodes.

Adjusting Stimulation Intensity

Instructions on how to adjust channel intensity controls, start low, and find a comfortable level.

Maintenance and Troubleshooting

Battery Information

Explains when to replace the battery and provides a step-by-step guide for the replacement process.

Caring for Your TENS Device

Guidance on cleaning the TENS unit and lead wires, and proper storage procedures.

Troubleshooting Common Issues

Addresses common problems like device not functioning, no stimulation, and provides solutions.

Technical and Warranty Information

Technical Specifications

Details device specifications including channel type, modes, intensity, pulse rate, width, and dimensions.

Output Specifications

Provides detailed output parameters for Burst, Continuous, and Modulation modes.

Limited Warranty Information

Outlines the warranty scope, how to obtain service, and disclaimers for remedies and damages.