67
Preparing for use (standard)
1. Open the access door on the outside of
your caravan or camper.
2. Remove the Waste Holding Tank by
pulling the safety catch (which holds the
tank in place) upwards.
3. Pull the Waste Holding Tank outward to
the stop. Tip it slightly and take the tank
fully out.
4. Place the tank upright and turn the
rotating emptying spout upwards. The
emptying spout ensures that the tank can
be easily and hygienically emptied.
5. Remove the cap, with the measuring cup
inside, from the emptying spout and pour
the correct dosage of Thetford toilet fluid
(see product label) into the holding tank.
This avoids unpleasant smells and keeps
the inside of the tank clean. Next add
approximately 2 litres of water - enough
to ensure that the bottom of the Waste
Holding Tank is covered. Far more
information on Thetford toilet fluids, see
last page of this manual. Screw the cap
back onto the emptying spout and turn
back to its original position.
Note: The Emptying Spout Measuring Cap is
supplied in the same packaging as this
manual.
WARNING: Never add toilet fluid directly
via the blade or the toilet bowl as this
could damage the lip seal of the Waste
Holding Tank. Always pour the fluids via
the emptying spout.
6. Slide the Waste Holding Tank back into
its original position via the access door.
Make sure that it is secured with the
safety catch. Close the access door and
lock it. Your Thetford toilet is now ready
to use.
WARNING: Never use force if you cannot
get the tank back into place easily. This
may cause serious damage. If blockage
occurs, always check if the blade handle
is in the correct (closed) position.
7. For toilets with own Flush-Water Tank:
Open the water filling door and fill the
flush-water tank with the correct dosage
of Aqua Rinse. This Thetford toilet fluid
keeps the flush water fresh and improves
the flushing. Next, fill up the flush-water
tank with clean water (approximately 8
litres) using a ferry can or hose. Your
toilet is now ready to use.
THETFORD TOILETS
Preparing for use with Optional
Features
8. Automatic Ventilator: Open the access
door on the outside of your caravan and
remove the Waste Holding Tank (as
described above).
9. Remove the filter housing cover and if
no filter is present, place a new filter
into the filter housing. Peel off the
sticker lids on the filter. Place back the
cover of the filter housing.
Using the toilet (standard)
10. Turn the bowl to the desired position
with the lid closed and using both
hands.
11.To activate the control panel, press the
flush-button once. The control panel
display will stay activated for
approximately 5 minutes. Run some
water into the bowl by pressing the flush
button again briefly.
12. The toilet may be used with the blade
open or closed. To open the blade, slide
the blade handle under the toilet bowl
sideways. After use, open the blade (if
still closed) and flush the toilet by
pressing the flush button for several
seconds (if necessary re-activate the
control panel). Close the blade after
use.
WARNING: If your toilet has its own
flush-water tank, please make sure that
To Next Page
Loading...
