14
GB
ORIGINAL INSTRUCTIONS
case of excessive contamination, replace the fi lter with a new one.
Clean the remaining parts of the vacuum cleaner with a cloth slightly soaked in water, then dry or allow to dry.
To clean the turbo brush shaft, disconnect the brush from the pipe or the vacuum cleaner, then slide the roller lock (XV) located
on the underside of the brush, dismantle the roller, clean it and reinstall it in the brush in the order reverse to that of disassembly.
The vacuum cleaner can be stored in the docking station. If the charger plug has been inserted into the docking station, make sure
that the charger is not connected to the power supply while the vacuum cleaner is in storage. The accessories can be connected
or disconnected from the vacuum cleaner for storage.
TECHNICAL PARAMETERS
Parameter Units Value
Catalogue No. 67120
Rated voltage [VDC] 22.2
Rated power [W] 120
Electrical protection class II
Dust container capacity [l] 1
Weight [kg] 0.8
Battery
- type Li-ion
- capacity [Ah] 2.2
- rated voltage [VDC] 22.2
Charger
- rated supply voltage [V~] 100 - 240
- rated frequency [Hz] 50/60
- rated power [W] 24
- rated output voltage [VDC] 27
- rated output current [mA] 500
- electrical protection class II
To Next Page
Loading...