Lund Malmo - Operation Guidelines Part 1; Electrical Connection and Grounding; Manual Controls and Heat Settings

- 19 -
Operation
General information
Unpacktheelectrical
replacecarefullyandkeepthepackagingforfutureuse,forexampleincase
you need to pack up the device if you are moving, or to return it to your specialist retailer.
Do not connect the heating device to the power supply, before it has been properly installed.
Note: If the device is used in an environment with only minor background noise, you may be able to
hearthesoundofthemotorusedtooperatetheameeffect.Thisisnormalandyoudonotneedto
be concerned.
Warning: The device is not equipped with a device for controlling the room temperature. The he-
ating device must not be used in small rooms that are occupied by individuals who are unable to
independently leave the room, unless constant supervision is ensured.
Electrical connection
WARNING: THIS DEVICE MUST BE GROUNDED
Caution: During operation, the device should not vibrate noticeably, as this may lead to failure of
the lamp. Please turn the device off before moving, servicing or cleaning it.
Manual operation
The switch is located on the back of the control panel which at the front of the fireplace heater.
There are three switches to control the heat settings.
Switchnumber1controlsthepowersupplyandameeffect.
Note: This switch must be turned to ON, to allow the device to operate with or without heat.
Switch number 2 controls heating with 1,000W (on / off)
Switch number 3 controls heating with 2,000W, together with switch number 2
Note:Theameeffectcanbeusedwithorwithouttheheatingfunction.