What to do if no water is flowing from my Lusso Plumbing Product?
If no water is flowing from your Lusso Plumbing Product, the isolation valves might be closed or partially closed. Make sure the isolation valves are fully open. Also, check the flexible hoses for kinks or blockages and ensure the pipes are not twisted or restricting flow. If the problem persists, the boiler may be blocked.
Why is the water not hot in my Lusso Plumbing Product?
If the water in your Lusso Plumbing Product is not hot, start by checking if the boiler is plugged in and the display is lit. Also, ensure that the circuit breaker and fuse are working correctly. Verify that the boiler is switched on and wait until the heating display stays lit before use. Finally, check if all four lights are lit on the touchscreen; if they are, you may need to remove any airlocks.
How to fix no boiling water flowing from Lusso Plumbing Product?
If no boiling water is flowing from your Lusso Plumbing Product, it could be due to the boiler being empty or not holding water. If the boiler is empty, follow the instructions for priming the installation. If the boiler isn’t holding water, check connections for any leaks.
What to do if water is dripping from the spout of my Lusso Plumbing Product?
If water is dripping from the spout of your Lusso Plumbing Product, it could be that the expansion chamber isn’t draining correctly. Run 500ml of water from the tap to clear and prime the system, and avoid drawing off less than 150ml per use. Alternatively, the spout could be blocked, so clean the aerator with a non-abrasive cleaner, such as a soft cloth, warm water, and washing-up liquid.
Why is water or steam spitting from the spout of my Lusso Plumbing Product?
If water or steam is spitting from the spout of your Lusso Plumbing Product, it could be because the unit is boiling. Press the boiling water touch control handle and release the water. You might also need to lower the water temperature setting or check if the aerator at the end of the spout is blocked. You may also need to remove any airlocks by following the priming the installation section.
What does it mean when the touch controls are flashing red on my Lusso Plumbing Product?
If the touch controls are flashing red on your Lusso Plumbing Product, it's a safety feature indicating that boiling water has been running for too long, which can cause overheating. Turn the power off, wait for two minutes, then turn the power back on. If the problem persists, further assistance may be required.
Why is the water too hot in my Lusso Plumbing Product?
If the water is too hot in your Lusso Plumbing Product, it's likely that the water temperature is set too high. Lower the water temperature setting.
How to fix slow flow from the spout of Lusso Plumbing Product?
If you're experiencing slow flow from the spout of your Lusso Plumbing Product, the water filter may need changing. Change the water filter every 6-12 months or your warranty will be void.
Steps to prime the tap and boiler after installation.
Procedure for replacing the water filter.
Instructions for switching the boiling water boiler on and off.
Guide to adjusting the water temperature on the boiler.
General| Brand | Lusso |
|---|---|
| Model | Filtrata |
| Category | Kitchen & Bath Fixtures |
| Language | English |
To Next Page