LUTEC 12513LE-SL - User Manual

Questions and Answers

K
Kristina JonesJul 28, 2025
What to do if my LUTEC 12513LE-SL Outdoor Light will not go on?
- F
  franklindevinJul 28, 2025
  If your LUTEC Outdoor Light isn't turning on, there could be several reasons. First, ensure the switch is set to 'ON'. If it is off, switch it to 'ON'. Second, the battery might be completely discharged; in this case, charge it for 6-8 hours. Also, check if the 'DUSK TO DAWN' feature is activated, and check it at night. The bulb could also be loose, so try re-tightening it. It's also possible that interference from another light source is the cause. If so, relocate the solar post light. Finally, make sure the solar panel is in direct sunlight to charge the battery.
T
Tony JohnstonAug 2, 2025
How to fix a shaking LUTEC 12513LE-SL fixture in high winds?
- C
  Christine ThompsonAug 3, 2025
  If your LUTEC Outdoor Light fixture shakes in high winds, it could be due to a few reasons. First, the mounting bracket might be loose; ensure the mounting bracket screws are tightened. Second, the insert may not be assembled completely or tightly. Make sure the insert is assembled completely and tightly. Finally, check that the screws and cap nuts were secured tightly.
T
Thomas AndersonAug 9, 2025
What to do if my LUTEC Lantern light will not go on?
- S
  Shawna WestAug 9, 2025
  If your LUTEC Lantern light won't turn on, there are several potential reasons. First, ensure the switch is set to 'ON'. If it's off, switch it on. Second, the battery may be completely discharged. In that case, charge it for 6-8 hours in direct sunlight. Also, check if the 'Dusk to Dawn' feature is activated, and test it at night. The bulb might also be loose, so re-tighten it. Another light source may be interfering, so relocate the solar post light. Finally, the battery may not be charging because the solar panel isn't in direct sunlight; make sure it is.
K
Kevin HernandezAug 14, 2025
Why does my LUTEC Lantern fixture shake in high winds?
- M
  Marisa AndersonAug 14, 2025
  If your LUTEC Lantern fixture shakes in high winds, the mounting bracket could be loose. Ensure the mounting bracket screws are tightened. Also, the insert may be loose, so ensure it is assembled completely and tightly. Finally, check that the screws and cap nuts were secured tightly.
A
April CastilloAug 20, 2025
How to fix LUTEC Lantern lights that come on during the daylight?
- K
  Kathryn WilliamsonAug 20, 2025
  If your LUTEC Lantern lights come on during the daylight, it might be because the light is installed in a dark location. Relocate it to a sunny location.