Lutron Electronics Caseta PD-5ANS - Page 16

16
by Lutron
7
Remove side sections (if necessary)
Do not remove outside side sections
on switches at the end of gang.
Each switch has inside side
sections removed.
Switch in the middle has
all side sections removed.
8
Connect the new Caséta Wireless neutral switch
Tagged Wire
Ground
(Green Wire)
9
Mount the Caséta Wireless neutral switch
10
Attach the wallplate
‘snap’
11
Remove existing switch from wall at Location 2
3-Way Installation - Caséta Wireless Neutral Switch with Pico Remote Control (PD-5ANS/PD-6ANS)
12
Tag and disconnect wires from the existing switch
Ground (Green / Bare Copper)
Different
Color
Screw
When installing more than one Caséta Wireless switch in the same wallbox,
it is necessary to remove inner side sections prior to wiring. See image and
chart below for more information.
Wallplate
Adapter
Wallplate
Location 1
Location 1
Location 2
Place tag - to identify wire on
different color screw
Location 2
Location 1
Important note:
Removing side sections reduces the switch’s maximum wattage rating.
See the chart below for maximum wattage information.
1
Neutral required.
2
The maximum lamp wattage is determined by the efficiency of the transformer, with
70% – 85% as typical. For actual transformer efficiency, contact either the fixture or
transformer manufacturer. The total VA rating of the transformer(s) shall not exceed the VA
rating of the switch.
3
The switch is ULR Listed for use with all magnetic and electronic fluorescent ballasts.
Red
Blue
Black
B
B B
C
B
A
PD-5ANS/PD-6ANS (120 V~)
1
LED 6 A 6 A 5 A
Halogen / incandescent 720 W 720 W 600 W
Electronic Low-Voltage 720 VA 720 VA 600 VA
Magnetic Low-Voltage
2
720 VA 720 VA 600 VA
Fluorescent
3
6 A 6 A 5 A
General Purpose Fan 3.6 A 3.6 A 3.6 A
A
B C
White
Neutral
connection
required