GB
39
Turning on the tool
P. 6, item 6
– Insert the circuit breaker (21) (pay atten-
tion to the fit)
P. 7, item 10
– Press and hold down the switch lock (8).
– Pull the switch on lever (1) and hold.
– Release the switch lock.
• The unit will switch itself on with approxi-
mately 2 seconds delay.
Switching-off the device
– Release the switch on lever.
Mowing
– Guide the unit at an even, slow pace
(walking speed) and with as straight a
path as possible.
Important notes
• Always work at right angles to the slope.
• Try not to cut grass when wet.
• Use overlapping paths to produce an
even cutting pattern.
• Cut longer grass with a greater cutting
height initially, then cut crosswise using
the desired cutting height.
P. 6, item 9
• If the air flap (22) closes, the collection
container is full and must be emptied.
Cleaning and maintenance
Cleaning and maintenance overview
Before each use
Cleaning the device
Clean unit immediately after every use. Dried
grass remains are very hard, and are very dif-
ficult to remove.
– Remove grass remains with a brush, and
a plastic scraper if required (do not use
sharp implements).
– Remove deposits on the wheels.
– Wipe the tool with a damp cloth.
– Never clean the unit with water or high-
pressure jet.
Changing the blades
Removing
P. 7, item 11
– Loosen the blade screw (23) using a 14
mm hexagon spanner.
– Remove the blade (24) carefully.
Installing
– Observe the installation direction: Blade
must fit, as shown, onto the cut-outs (25).
– Carefully attach the blade (24).
– Tighten the blade screw (23) using a 14
mm hexagon spanner (35-40 Nm).
Storage, transportation
Storage
Note: The product cannot be
switched on without the circuit
breaker.
WARNING! Risk of injury! Before
starting work, check the area and
remove all objects which may be
kicked up by the unit.
DANGER! Risk of injury! Carry out
the maintenance work described
here in person.
Improper maintenance work can
damage the device and lead to inju-
ries.
DANGER! Risk of injury! Before
carrying out any maintenance or
cleaning work, the machine must be
disconnected from the power and
secured to prevent accidental switch
on.
What? How?
General function check. Visual check.
Check all screw connec-
tions and tighten if neces-
sary.
CAUTION! Risk of injury! Never
touch the blade on the cutting edge.
Wear gloves at all times when work-
ing with the blade.
NOTICE! Risk of damage to the
device! Pay attention to the rotation
direction of the blade (arrow).
DANGER! Risk of injury! Store the
unit in such a way that it cannot be
started by unauthorised persons.
Ensure that no one is able to hurt
themselves on the stored unit.
Rasenmaeher_Akku_196074.book Seite 39 Donnerstag, 5. Dezember 2019 2:04 14
To Next Page
Loading...
