Why is the sawing performance not good enough with my Lux Tools KS-1200 Saw?
If the sawing performance of your Lux Tools Saw isn't satisfactory, it might be because the saw blade is blunt or not suitable for the material you're cutting. Try replacing the saw blade or using one that's appropriate for the material.
What to do if my Lux Tools KS-1200 vibrates heavily?
If your Lux Tools Saw vibrates heavily, it could be due to a distorted or incorrectly mounted saw blade. Replace the distorted saw blade and ensure the new one is mounted correctly. Do not continue using a distorted saw blade, and dispose of it properly.
How to troubleshoot a Lux Tools Saw when the motor does not work?
If the motor of your Lux Tools Saw isn't working, begin by checking the cable, plug, and fuse to ensure there's a proper power supply. Also, if there was a temporary power failure, the under voltage relay might have been triggered. Try turning the unit on again.
What to do if there's increased shavings in flight with my Lux Tools KS-1200 Saw?
If you observe increased shavings in flight while using your Lux Tools Saw, the dust collection bag might be full, or the feed to the dust collection bag could be blocked. Empty the dust collection bag, and if necessary, clean the feed using a brush or vacuum.
What to do if the tool arm is blocked on my Lux Tools Saw?
If the tool arm of your Lux Tools Saw is blocked, check whether the safety pin is pushed in or the unlocking button hasn't been pressed. Remove the safety pin and operate the unlocking button.
What to do if the engine overheated on my Lux Tools Saw?
To address an overheated engine in your Lux Tools Saw, eliminate the cause of overheating, allow the tool to cool down for a few minutes, and then switch it on again.
General| Power | 1200 W |
|---|---|
| Blade diameter | 190 mm |
| Cutting depth at 90° | 66 mm |
| Cutting depth at 45° | 47 mm |
| Power source | Electric |
To Next Page
