What to do if my Lux Tools ZKGS-1600 Tools motor does not run?
If the motor does not run, consider these potential causes: * **No mains voltage?** Check the cable, plug, socket, and fuse. * **Undervoltage relay triggered?** If a temporary power loss occurred, switch the product on again. * **Motor overheated?** Eliminate the cause of overheating, allow the motor to cool down for a few minutes, and then switch it on again.
Why is the saw power too low on my Lux Tools ZKGS-1600 Tools?
The saw might have low power due to: * A blunt saw blade. In this case, you should replace the saw blade. * Using an unsuitable saw blade for the material. Ensure you use suitable saw blades for the material you are cutting.
What to do if the Lux Tools ZKGS-1600 Tools saw vibrates severely?
If the saw vibrates severely, consider these potential causes: * **Contorted saw blade?** Replace the saw blade; do not use warped saw blades and discard them. * **Saw blade fitted incorrectly?** Fit the saw blade correctly.
Why is there an increased amount of flying swarf from my Lux Tools Tools?
An increased amount of flying swarf may occur if the dust bag is full or the inlet to the dust bag is blocked. Empty the dust bag and clean out the inlet with a brush or vacuum cleaner.
What to do if the tool arm is blocked on my Lux Tools Tools?
If the tool arm is blocked, check the following: * **Safety bolts pushed in?** Pull out the safety bolts. * **Release button not pressed?** Actuate the release button.
To Next Page
General