ASSEMBLY INSTRUCTIONS
• Remove the protective plastic lm from the base of the
lamp to reveal the stabalizing pad.
• Clean the intended installation surface to remove dust or
particulates. If bottom of lamp loses its stickiness, it can be
cleaned with a wet cloth.
• A tripod screw mount is also included, for a more
permanent installation.
• Install the included power cord to rear of lamp and then
plug into any wall outlet.
USING YOUR LUX HIGHLINE LED LAMP:
• Turn the light on by touching the power button on the front
of the lamp.
• Press the power button again to cycle through the three
brightness levels (1,000, 400, 60 lumens).
• The light head will rotate horizontally, but is not intended
to bend up or down. Do not put push or pull the light head
upwards or downwards.
• When using the lamp to charge your devices, unplug or
remove the devices once batteries are full.
SAFETY INFORMATION:
• The exible external power supply cable cannot be
replaced; if the cable is damaged the entire power supply
must be replaced.
• For indoor use only; do not use outdoors or in damp
locations.
• Switch the lamp off before disconnecting the power.
• Do not look directly at the LEDs when they are illuminated.
To Next Page
Loading...