Switching plates
The floor nozzle comprises of two plates; the bristle
plate for hard floors and the carpet plate for carpets and
rugs.
To switch the plates, press the clip on the lower part of
the plate and lift it off. Fit the required plate and press
the clip until it can be heard to click into place.
Connecting to the mains
Extend the power cord and connect the electrical
plug to the mains. Note the red mark indicating the
end of the cord. To rewind the cord, slightly pull it
back (2.5 cm) and release it. The cord will rewind
automatically.
Switching on and off
After your LUX sora has been connected to the
mains, the green ready-for-operation light on the
appliance will illuminate. The LUX sora is switched
on and off by means of the sliding switch on the
handle. Select the desired performance setting
between “A and 3”. Performance setting “A” is an
automatic function designed for the EB360
accessory. On level “A”, the LUX sora will
automatically adjust its suction power to the surface
conditions. It is mainly meant for loose rugs and
carpets.
To Next Page
Loading...