Nozzle Mode Knob
Cold & Hot Water Inlet
Water Flow Control Handle
Adjustable Plates
Wash nozzle
Femine Nozzle
Assembly Instruction
LUXE Bidet
R
Nozzle Guard Gate
2
Remove the seat by unscrewing the seat.
Place the bidet on the toilet.
Plates may be adjusted
depending on where the two
holes in the back of the toilet are.
3
Top View of Toilet
Bidet should now be aligned with
the coupling holes.
4
Note: You may not need to
use this part from the kit since
a typical water connection is a
flexible metal hose with a15/16”
toilet tank connection and 9/16”
toilet water supply connection.
Flexible Water Supply Hose
1/2” T-Adapter Connection
1/4” Bidet Connection
22” Length
15/16”
15/16”
1/2”
Rubber Washer
Toilet Tank Connection
Bidet Hose
Connection
Toilet Hose Connection
Plastic T-Adapter
(Cold Water)
15/16” Toilet Tank Connection
9/16” Toilet Water
Supply Connection
PARTS
Flexible Metal Braided Hose
(Cold Water)
Bidet
Connection
1/4”
Metal
Wing Nut
10’ Length
Metal T-Adapter
Connection
8 mm
Polyurethane Hose
(Hot Water)
Hot Water Inlet Cap
with Rubber Washer
3/8”
Wing
Nut
8 mm
3/8”
Sink Hose
Connection
Sink Water
Connection
(Wall Outlet)
Bidet Hose
Connection
Metal T-Adapter
(Hot Water)
Rubber Washer
OPTIONAL PARTS
Note: You only need this part if you
do not connect the hot water. See
troubleshooting for more details.
1
Shut off the toilet water supply.
Flush toilet to empty the tank.
Toilet
Water
Supply
Valve
Screw the seat back on to the bidet
and the toilet.
5
TM
LUXE Bidet
R
TM
NEO250 & NEO320
NAMES AND FUNCTIONS OF PARTS
*Please note: illustrations may vary depending on the model
Installation Tools
You May Need
Wrench
Screwdriver(flat)
To Next Page
Need help?
General
