42
SUPER AUDIO CD PLAYER D-10X
Problem Cause/Solution Ref. page
No sound is generated from the
speakers, or sound is distorted.
• Confirm that all audio cable connections are correct. 19 - 20
• If a digital output device is connected to this unit, set [Digital output]
to [On].
11
• Clean the disc to remove dirt.
2
• When the output level of an amplifier, etc. is minimum, adjust the
volume.
• Confirm that the cable connectors are connected and firmly inserted
into the terminals of all unit.
• Clean the cable connectors and terminals by using a plain dry cloth
or a cloth dipped in a small amount of dehydrated alcohol.
Digital audio signals cannot be
output digitally.
• Set [Digital output] to [On].
11
• When the HD layer of a Super Audio CD, a DSD file, or a PCM file with
sampling frequency of 352.8 kHz, 384 kHz, 705.6 kHz or 768 kHz is
played back, a digital audio output is not available.
18
The output levels of SACD and
CD are quite different.
• This is due to the difference in recording format.
This unit may not work normally when the unit is subject to external influence such as static electricity. In such a case, normal operation
may resume by turning off the power once and turning on the power again after several tens of seconds or returning the unit to the factory
setting. If the problem is not solved, please contact your dealer or our service center.
To Next Page
Loading...
Need help?
General
