19
Operations
How to use the headphone output
Insert the standard plug of headphones into the headphone
jack (PHONES) on the front panel of this unit after the volume
control is rotated counterclockwise to the end.
Start the playback of the input device, and rotate the volume
control slowly clockwise to your favorite sound volume.
Whenever the power is turned on and off, the input selec-
tor is changed over, or the headphone plug is connected or
disconnected, be sure to rotate the volume control counter-
clockwise to the end to set the sound volume to the mini-
mum.
If the headphones are used for a long time at a high sound
volume level, your hearing may be damaged.
Applied use of the analog output terminals
If the analog output level fix/variable selection switch (FIX/
VARIABLE) is set to VARIABLE and the analog unbalanced
output terminals (RCA) of this unit are connected to the
main in terminal (MAIN IN) of an integrated amplifier (such
as LUXMAN L-505uX) that is equipped with the separate
function, the pre-amplifier section can be used as a newly-
designed pre-amplifier circuit.
To Next Page