Need help?Do you have a question about the Luxman LE-109 and is the answer not in the manual?
Power| power supply voltage | 120/200/240 V |
|---|---|
| power consumption | 25 W |
Audio Specifications| output impedance (Phono 1) | 70 ohms |
|---|---|
| output voltage (Phono 1) | 150 mV |
| total harmonic distortion (1 kHz) | 0.005 % |
| input sensitivity (Phono 1) | 160 µV |
| input impedance (Phono 2, MM) | 47k/100 ohms |
| input impedance (Phono 2, MC) | 3/40/100 ohms |
| signal-to-noise ratio (MC) | 77 dB |
| signal-to-noise ratio (MM) | 92 dB |
Frequency Response and Filters| frequency response (Phono MM/MC) | 20 Hz — 30 kHz (-1.0 dB) |
|---|---|
| frequency response | 30 Hz — 20, 000 Hz (+0.5 dB) |
| crosstalk (Phono 1) | 85 dB |
| subsonic filter | 18 Hz, -3 dB/oct |
Weight and Dimensions| width | 438 mm |
|---|---|
| height | 63 mm |
| depth | 310 mm |
| weight | 4.5 kg |
Turns the unit ON/OFF.
Reduces low-frequency noise to protect woofers from warped records.
Allows attenuation switching in three steps: 0 dB, -10 dB, and -20 dB.
Used to select between Phono-1 (MC) and Phono-2 (MM or MC) players.
Selects sensitivity based on cartridge type for Phono-2.
Selects impedance based on cartridge type for Phono-2.
Connects Player-1 (MC cartridge) to the unit's Phono-1 terminals and GND.
Connects Player-2 (MM or MC cartridge) to the unit's Phono-2 terminals and GND.
Connects the unit's output to an integrated amplifier and speakers.
Connects the unit to an AC power source.
Turns the unit ON, waits for muting circuit to stabilize, then plays sound.
Selects Phono-1 for MC cartridges, offering a direct signal path.
Selects Phono-2 for MM or MC cartridges and adjusts sensitivity/impedance.
Sets input sensitivity for MM (0 dB) or MC (22 dB, 32 dB) cartridges.
Matches impedance (3, 40, 100 ohm) for MC cartridges.
Temporarily reduces output level by -10 dB or -20 dB.
Filters out ultra-low frequencies caused by warped records or motor noise.
Details rated output power, output impedance, and total harmonic distortion.
Lists input sensitivity and impedance values for Phono-1 and Phono-2 inputs.
Provides frequency response range and crosstalk attenuation for Phono-1.
Details power supply, consumption, dimensions, and weight of the unit.
To Next Page