Why Luxor LED65FSWB TV will not turn on?
If your Luxor TV isn't turning on, ensure the power cord is securely plugged into the wall outlet. Also, check the remote control batteries, as they may be exhausted. If neither of those solutions work, try pressing the Power button directly on the TV.
What to do if Luxor LED65FSWB TV has no picture?
If your Luxor TV shows no picture, first, ensure you've selected the correct button on the remote control and try again. Verify that the correct input source is selected. Check if the antenna is connected properly and that the antenna cable isn't damaged. Also, make sure you're using suitable plugs to connect the antenna.
How to fix poor picture quality on Luxor TV?
To improve poor picture quality on your Luxor TV, ensure you've selected the correct TV system. Check your antenna access, as a low signal level can cause picture distortion. If you've done manual tuning, verify that you've entered the correct channel frequency. Also, the picture quality may degrade when two devices are connected to the TV at the same time; in such a case, disconnect one of the devices.
What to do if Luxor LED65FSWB TV input sources can not be selected?
If you cannot select input sources on your Luxor TV, it's possible that no device is connected. If you have tried to connect a device, check the AV cables and connections.
What to do if my Luxor TV has no sound?
If your Luxor TV has no sound, first check if the TV has been set to mute. To cancel mute, press the “ ” button, or increase the volume level. Also check the Sound Menu section in the TV settings, because the balance might be set to one extreme.
Why my Luxor LED65FSWB remote control does not operate?
If your Luxor TV remote control isn't working, the batteries may be exhausted. Replace the batteries with new ones.
Why recording is unavailable on Luxor LED65FSWB TV?
If recording is unavailable on your Luxor TV, connect a USB disk to your TV while the TV is switched off. Then, switch on the TV to enable the recording feature. If you still cannot record, try switching off the TV and then re-inserting the USB device.
What does it mean if USB is too slow on Luxor LED65FSWB?
If a “USB is too slow” message is displayed on the screen while starting a recording on your Luxor TV, try restarting the recording. If you still get the same error, it is possible that your USB disk does not meet the speed requirements. Try connecting another USB disk.
General| Display Technology | LED |
|---|---|
| Refresh Rate | 60 Hz |
| Smart TV | Yes |
| HDMI Ports | 3 |
| USB Ports | 2 |
| Built-in Wi-Fi | Yes |
| Screen Size | 65 inches |
| Operating System | Android |
Warnings about electrical shock, safe operating environment, and proper placement to prevent damage.
Guidelines for safe power cord handling, protection against liquids, and general user safety.
Detailed guide on using the remote control for TV operation.
Comprehensive guide to all remote control buttons and their specific functions.
Explanation of all available TV input/output connectors and their uses.
Step-by-step guide for initial TV setup, language selection, and channel tuning.
Detailed instructions for recording TV programs, timeshifting, and instant recording.
Adjustments for picture quality including mode, contrast, brightness, and advanced fine-tuning.
Settings related to audio output, equalizer, balance, sound modes, and digital output.
Using EPG, setting timers, and connecting to a wired network for internet.
How to upgrade software and troubleshoot problems like no picture, sound, or remote control issues.
To Next Page
