Need help?Do you have a question about the Luxul XWR-3100 and is the answer not in the manual?
General| Wireless Standard | 802.11ac |
|---|---|
| Frequency Bands | 2.4 GHz and 5 GHz |
| Weight | 1.5 lbs |
| USB Ports | 1 x USB 3.0 |
| MU-MIMO | Yes |
| VPN Support | Yes |
| Ethernet Ports | 4 x Gigabit LAN, 1 x Gigabit WAN |
| Security | WPA2 |
| Maximum Wireless Speed | 3100 Mbps (1000 Mbps on 2.4 GHz + 2167 Mbps on 5 GHz) |
Log in to the router using the default IP address, username, and password via a web browser.
Set the internet connection type (DHCP, PPPoE, or Static) based on ISP requirements.
Set or leave the router's local network IP address, typically ending in .1 or .254.
Set up the 2.4GHz Wi-Fi network by configuring SSID, security mode, encryption, and passphrase.
Configure the 5GHz Wi-Fi network following similar steps as the 2.4GHz network.
Save configuration changes and reboot the router for them to take effect.
Enable the Wireless Controller, ensure APs are powered on and factory default, and prepare for assignment.
Select unassigned access points and add them to the controller via the AP Assignment page.
Confirm added access points appear in the AP Summary with an online status.
Navigate to the Admin Password section under the Administration menu.
Enter and confirm the desired new password for administrator login.
Save the new admin password and reboot the router to apply the changes.
To Next Page
