To Next PageTo Next Page
Need help?Do you have a question about the LYDKRAFT TUBE-TECH MEC-1A and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Outputs | XLR |
| EQ Bands | 3 |
| Tube | Yes |
| Inputs | XLR |
| Frequency Selection | Yes |
| Frequency Response | 20Hz - 20kHz |
Details core functionalities like microphone preamplifier, equalizer, and compressor.
Specifies gain, phantom power, phase reverse, pad, lowcut filter, and DI input.
Outlines EQ bands, frequency options, gain ranges, and filter types.
Lists compressor type, stereo linking, attack/release, and ratio settings.
Covers output gain, relays, VU meter, frequency response, noise, and power supply.
Lists input and output impedance values for microphone, DI, and general output.
Details the types and quantities of tubes used within the unit.
Provides the unit's height, width, and depth in metric and imperial units.
Specifies the net and shipping weight of the device.
States the voltage, frequency, and power consumption of the unit.
Contains disclaimers and conditions for the provided specifications.
Contact details for the authorized dealer.
Summarizes the MEC 1A as a combined microphone preamplifier, equalizer, and compressor.
Explains gain stages, filters, PAD, phantom power, and DI input functionality.
Describes the EQ's shelving, bell filters, frequencies, bandwidth, and bypass.
Details the optical compressor, its controls, and signal routing options.
Explains how to link multiple compressors using side chain connections.
Explains the VU meter's two modes: output level and compression.
Describes the output gain control for makeup gain after compression.
Details controls for gain (coarse/fine), low cut filter, phantom power, and PAD.
Describes the direct input for instruments and its gain range.
Introduces equalizer controls, including low shelf gain.
Details the low shelf EQ gain control and its variability.
Describes midband EQ gain, frequency selection, and bandwidth control.
Details the high shelf EQ gain and frequency selection.
Explains the switch to engage or bypass the equalizer section.
Explains the compressor ratio control and its variable range.
Defines the threshold control for compressor activation.
Describes the switch to bypass the compressor's side chain.
Explains the attack control for compressor response speed.
Explains the release control for compressor response speed.
Details the switch for selecting fixed vs. manual attack/release.
Explains the switch for interconnecting multiple compressors.
Describes the output gain control for makeup gain and its range.
Details the two positions of the VU meter selector: Compression and Output.
Explains the switch for routing order between EQ and compressor.
Details DC voltage adjustments for the power supply unit.
Describes offset voltage adjustments for tube operational amplifiers.
Specifies the calibration range for a specific parameter.
Provides steps for setting the basic input gain of the unit.
Procedure for adjusting the low shelving equalizer gain.
Procedure for adjusting the high shelving equalizer gain.
Procedure for adjusting the midband equalizer gain.
Procedure for adjusting the compressor's tracking accuracy.
Procedure to calibrate the VU meter for compression readings.
Summarized input/output impedance values.
Lists the types and quantities of tubes used.
Specifies the -3dB frequency response range.
Summarizes THD+N, noise, and CMRR figures.
Details max output/input levels and gain ranges.
Summarizes unit dimensions and weight.
Specifies power requirements and consumption.
Summarizes compressor ratio, threshold, attack, and release parameters.
Contains important notes and supplier disclaimers.
