The Winny Robotic Pool Cleaner, model HJ2152, is an advanced, energy-saving, and highly efficient device designed for automatic cleaning of swimming pools. It operates autonomously, cleaning both the pool walls and bottom, and simultaneously filters the pool water to remove suspended particles without requiring water replacement, making it an environmentally friendly solution. For safe operation, the cleaner is powered by a rechargeable lithium battery (25.9V 7.8Ah).
Function Description:
The robotic pool cleaner utilizes an advanced computer-controlled program to navigate and clean the pool. It is designed to immerse into the pool and, after expelling all internal air, settle on the pool floor to begin its cleaning cycle. Upon completion of its work, the cleaner will "self-beach," moving to the edge of the pool for easy retrieval using a hook.
Important Technical Specifications:
- Name: OPSON WS
- Model: HJ2152
- Charger Input: 100Vac-240Vac; 50Hz/60Hz
- Charger Output Voltage: 30V
- Charger Output Current: 2A
- Max Power: 130W
- Working Cycle: 120 minutes
- Charging Time: 4-5 hours
- Battery Capacity: 7800mAh
- Max. Cleaning Surface: 120m²
- Filter Capacity: Approximately 16m³/min
- Filter Capability: 180µm
- Moving Speed: Approximately 10m/min
- Working Environment Temperature: 0°C-40°C
- Charging Environment Temperature: 10°C-40°C
- IP Grade: IPX8
- Max. Water Depth: 2m
Usage Features:
- Operation: To power on, push the switch towards the right; the blue indicator light will illuminate. To power off, push the switch towards the left; the red indicator will flash once.
- Placement and Retrieval: When placing the cleaner into or lifting it out of the pool, always orient its bottom towards the wall to prevent scratches. Hold the top handle and gently immerse it. Ensure all air is expelled from the cleaner for proper operation. After cleaning, the device will self-beach, allowing for easy retrieval with a hook.
- Indicator Lights:
- Blue light steady on: Cleaner is switched on.
- Blue light flashes: Cleaner is working.
- Yellow light flashes: Low battery and self-beaching initiated.
- Yellow light steady on: Self-beaching completed.
- Red light steady on: Cleaner is switched off.
- Red light flashes: Indicates a fault. If a fault occurs, switch off the cleaner, charge it, then place it back in the pool and switch it on again. If the issue persists, contact customer service.
- Charging:
- Always remove the cleaner from the pool and place it indoors, at least 3.5m away from the pool, before charging.
- Ensure the charging port is dry and the cleaner is powered off before connecting the charger.
- Use only the original charger and connect it to a leakage-protected and earthed socket.
- Charging Indicator: A red light indicates the battery is being charged, while a steady green light signifies that charging is complete. If the red light flashes, it indicates low battery or a damaged battery.
- Avoid charging a full battery to prevent overcharging and reduced battery life.
- Do not charge the battery for more than 6 hours.
- If storing the cleaner for a long period, charge it every 6 months to maintain battery life.
Maintenance Features:
- Filter Tray Cleaning:
- Press the opening button to release the top cover.
- The top cover will automatically pop up.
- Open the top cover completely.
- Take out the filter basket.
- Clean the filter baskets thoroughly.
- Re-install the filter baskets, paying attention to their correct installation position, and then close the top cover.
- Storage: Store the cleaner in a cool, ventilated place, away from direct sunlight.
- Battery Care:
- Avoid dropping or hammering the battery and cleaner.
- Do not use the cleaner in environments above 40°C or below 0°C.
- Charge the battery in environments between 10°C and 40°C. If the battery is overheated, allow it to cool before recharging.
- Charge the cleaner before the battery is completely exhausted; stop use and charge when power decreases.
Safety Precautions:
- Read the manual carefully before use. The manufacturer is not liable for loss or injury due to improper use.
- Do not allow children to ride on or play with the cleaner.
- Never operate the cleaner when people are in the pool.
- Never power on the cleaner when it is out of the swimming pool to prevent severe damage.
- Only professionals should disassemble the sealed driving kit.
Need help?
General
To Next Page
