Page 23
LEDs
Illuminated
Display
shows
What happened?
Intruder Zones no. , Movement was detected in
this zone.
Tamper Zones no. The tamper switch on this
detector was activated.
Tamper The tamper switch on the
control unit was activated.
Tamper The tamper switch on the
external siren box was
activated.
Tamper The tamper switch on one
of the wired detectors was
activated.
Interference Jamming of radio
transmission was detected.
When you have viewed and noted all alarm events, press:
Press ,display now shows and system is in “Standby”.
Note that if you have purchased some of the accessories available for your system, you may obtain
other indications as shown below:
LEDs
Illuminated
Display
shows
What happened?
None A personal attack (panic)
button was pressed.
c) Silencing the System when the alarm is sounding
If you accidentally trigger a detector when the system is armed, the external and internal siren will
sound and the external strobe will flash. If an attempt was made to tamper with any part of the
system with the control unit in “Standby”, then only the internal siren will sound.
To silence the system in such a case, follow procedure in section “b” above.
4.7 Features of the Remote Control Key
Full Arm -- Press to full arm the
system
Partial Arm 3 -- Press to partial arm the system with partial arm 3
Disarm -- Press to disarm the system
Full Arm + Partial Arm 3 -- Panic
4.8 Changing in Cordless Detector Batteries
Every LS5000 cordless detector will detect when its batteries are in need of replacement. When this
occurs, a “low battery” transmission is sent to the control unit and a low beep will be sounded when
the detector is triggered.
RESET
To Next Page
Loading...