Lynx E22 - User Manual

APx500 Flex Setup Guide
Lynx E22
Overview
Before a Lynx E22 can be used with APx500 Flex, the device driver must be installed and the gain
settings configured appropriately using the Lynx Mixer application. Follow the steps below to set up
your device.
Driver installation
1. Connect a powered Lynx E22 to your computer over USB.
2. Download the latest device driver for your operating systems from the Lynx website.
3. Install the driver and reboot your PC.
Configuring Lynx Mixer
4. Launch Lynx Mixer from the Windows toolbar.
5. Select MixerRestore Defaults from the toolbar.
a. Gains should all be set to 0.0.
b. Analog output and input trims should be set to +20 dBu FS.
At this point your settings should resemble those in the screenshot, below.
(ES) Equipements Scientifiques SA - Département Tests & Mesures - 127 rue de Buzenval BP 26 - 92380 Garches
Tél. 01 47 95 99 45 - Fax. 01 47 01 16 22 - e-mail: tem@es-france.com - Site Web: www.es-france.com

Lynx E22 Specifications

General

A/D Resolution	24-bit
D/A Resolution	24-bit
Maximum Sample Rate	192 kHz
THD+N	-110 dB
Digital I/O	AES/EBU, S/PDIF
Supported OS	Windows, macOS
Channels	2
Analog Inputs	2
Analog Outputs	2
Clock I/O	Word Clock

Summary

Lynx E22 Setup Guide

Driver Installation

Steps to install the Lynx E22 device driver on a computer.

Configuring Lynx Mixer

Configure the Lynx Mixer application by restoring defaults and setting trims.

Manual Calibration for Lynx E22

Output Sensitivities

Specify the scaling factor for analog outputs 1-2.

Input Sensitivities

Specify the scaling factor for analog inputs 1-2.