Page 3
Lynx Grills Inc.
L24REF
Proper Disposal of Your Old Appliance:
Old refrigerators can represent a suffocation hazard to children!
1. Remove the doors from your old refrigerator .
2. Leave shelves in place.
3. If an old refrigerator contains refrigerants, it must be recycled by a licensed service or disposal company.
UNPACKING
Excessive Weight Hazard! * Use two or more people to move and install your appliance.
Failure to do so can result in back or other injury.
ALLOW APPLIANCE TO SIT UPRIGHT FOR 24 HOURS BEFORE TURNING ON, TO ALLOW THE
COMPRESSOR LUBRICANT TO DRAIN.
1. Remove Packaging Materials
2. Remove tape and glue residue from surfaces before turning on the appliance. Rub a small amount of liquid
dish soap over the adhesive with your fingers. Rinse with warm water and dry.
3. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or
glue. These products can damage the surface of your appliance.
4. When Moving Your Appliance:
Your appliance is heavy. When moving the appliance for cleaning or service, be sure to protect the floor.
Always pull the appliance straight out when moving it. Do not wiggle or “walk” the appliance when trying to
move it, because floor damage can occur.
5. Clean Before Using
After you remove all of the packaging materials, clean the inside of your appliance before using it. See the
cleaning instructions in “Appliance Care.”
6.If necessary level the refrigerator as needed for best operation.
Keep flammable materials and vapors, such as gasoline, away from appliances. Failure to do so can
result in death, explosion, or fire.
LOCATION REQUIREMENTS
IMPORTANT: Do not install the appliance near an oven, radiator, or other heat source,.
Check the strength of the floor before installing your appliance. It should hold the weight of the fully loaded
appliance. Allow at least 1” (2.5 cm) of airspace at the top and on both sides of the appliance and 1” (2.5 cm)
between the back of the appliance and the wall. If the appliance is going to be placed against a wall, leave
extra space on the hinge side so the door can open wider than its width.
BE SURE THAT YOU DO NOT BLOCK THE AIRFLOW UNDER THE APPLIANCE .
INSTALLATION INSTRUCTIONS
To Next Page
Loading...
Need help?
General
