Need help?Do you have a question about the Lynx Safari 400 F and is the answer not in the manual?
General| Brand | Lynx |
|---|---|
| Model | Safari 400 F |
| Category | Offroad Vehicle |
| Language | English |
Controls engine speed and transmission engagement.
Applies the brake when compressed.
Engages parking brake for securing the snowmobile.
Controls ignition, starting, and reverse functions.
Shuts off engine if operator falls off.
Indicates engine temperature is too high.
Specifies the type of oil for the engine.
Procedures for engine overheating.
Checking oil levels in chain case/gearbox.
Checking oil level in injection system.
Checking coolant level.
Beeper code for DESS connection issues.
Beeper code for wrong tether cap.
Beeper code for engine overheating.
Beeper code for low oil pressure.
Beeper code for low battery voltage.
Beeper code for engine management system defect.
Beeper code for engine management system defect.
Troubleshooting engine failure to start.
Troubleshooting lack of acceleration/power.
Troubleshooting engine backfires.
Troubleshooting engine misfires.
Troubleshooting inability to reach full speed.
Steps to follow for warranty claims.
Indicates engine temperature is too high.
Best practices for suspension adjustment.
Adjusting rear springs for comfort.
Procedures for stopping the vehicle.
Manual starting for SDI engines.
Procedures for emergency starting.
To Next Page