Lyons NanoVNA - 5. Start measurement; i. Basic measurement sequence; 6. Calibration method; 7. Function

08/09/2020 NanoVNA User Guide | NanoVNA User Guide
https://cho45.github.io/NanoVNA-manual/#7- トレース 状 態 2/51
b. 13. Back key
c. 14. Unit key
d. 15. Input eld
5. Start measurement
i. Basic measurement sequence
6. Calibration method
7. function
i. Trace display
a. Trace format
b. Trace channel
ii. marker
iii. Time domain operation
a. Time domain bandpass
b. Time domain low pass impulse
c. Time domain lowpass step
a. Step response example
d. Time domain window
e. Setting the wavelength reduction factor (Velocity Factor) in the time domain
f. Set frequency from marker
iv. Setting the measurement range
a. Setting the start frequency and stop frequency
b. Set center frequency/span
c. Zero span
d. Temporarily stop measurement
v. Calibration and setup recall
vi. Equipment settings