Lyons NanoVNA - Page 28

08/09/2020 NanoVNA User Guide | NanoVNA User Guide
https://cho45.github.io/NanoVNA-manual/#7- トレース 状 態 28/51
Temporarily stop measurement
STIMULUS PAUSE SWEEP Select to temporarily stop the measurement.
Calibration and setup recall
You can save up to 5 calibration data. The N anoV N A loads the data of number 0 immediately after starting.
Calibration data is data that includes the following information.
Frequency setting range
Error correction at each measurement point
Trace setting status
Marker setting status
Domain Mode Settings
Setting wavelength reduction rate
electrical delay