Mounting on Stand:
1. To mount shield on microphone stand, start by loosening Clamp Levers (6) by turning counterclockwise.
2. If necessary, use hex key to loosen Stand Clamp (5) screws.
3. Slide microphone stand through Stand Clamps (5) and tighten levers by turning clockwise.
Mounting Microphone:
Included with your microphone shield is a set of microphone mounting hardware. The set consists of a support pole,
a support bar, and two washers. To mount your microphone, follow these steps:
1. Remove middle Stability Foot (3) by turning counterclockwise.
2. Stick threaded end of foot through round hole in support bar, as shown.
3. Replace foot along with support bar by turning clockwise.
4. Unscrew bottom of support pole by turning counterclockwise.
5. Remove one washer while leaving other one on pole.
6. Stick threaded end of pole through longer hole in support bar, as shown.
7. Replace second washer and bottom by turning clockwise. Do not tighten yet.
8. Mount microphone to top of support bar, then proceed to tighten pole in place.
Specications
Coloration: Approximately 1dB
Dimensions: 16.9˝ x 15˝ x 12.8˝
Weight: 6.2 Pounds
Mounting Hardware:
- Maximum Length: 5.9˝
- Motion Range: 4.5˝
- Supporting Height: 4.1˝
www.lyxpro.com
Distributed by
C&A Marketing, Inc.
2 Bergen Turnpike
Ridgeeld Park, NJ 07660
info@lyxpro.com
MADE IN CHINA
LyxPro is a trademark of
C&A IP Holdings, LLC
©2015 All Rights Reserved
To Previous Page
Loading...